Instalación

The solid wood cladding of Grupo Molduras is very easy to install: no building works, cleanly…

1.-Make sure the surface to be covered is completely damp-free.

An easy way to check if a wall accumulates humidity is to fix a plastic of 50 x 50 cm. on the wall. Leave it there for the whole day using adhesive. If the color changes the wall has humidity and it will be necessary to dry it.

If, on the other hand, it is dry or submitted to harsh heating systems, fit the panels closely together.

2.-Lean the panels for several days against the wall on which they are to be placed. This will allow them to adapt to the new environment conditions. Do not leave them in direct contact with the floor.

3.-Check the conditions of each panel. If varnish, paint or other finishes are to be applied, we recommend the use of nitro-cellulose or synthetic coverings (under no circumstances are floor varnishes to be applied). Apply it to each panel before fitting the panel, forming a flexible film. For stained or varnished products remember that this is a finished product and no other type of finish should be applied on top.

4.-The natural cladding should be installed outdoors only when treated with a protective cover.

Please, read the technical information issue

1.-Fix the wood strips with steel nails, making sure the distance between them is no more than 50 cm. Place them in a vertical position if the panels are to be placed horizontally or vice versa

2.-Next, join the panels to the supporting frame, beginning in a corner and making sure the section to be fixed to the wall is on the same side as the rest of the panels

3.-Join the panels using nails or clips. Ideally, the panels should not touch either the floor or the ceiling. We recommend leaving a total gap of around 2 cm (either from the floor or ceiling or both)